Add constants at the beginning of the mk file

[bertos.git] / bertos / cpu / avr / drv / kdebug_avr.c

diff --git a/bertos/cpu/avr/drv/kdebug_avr.c b/bertos/cpu/avr/drv/kdebug_avr.c
index 53d91895560381dac1dcc48454d5f685b597370f..d8e146372352c158242b41499194990788a63342 100644 (file)
--- a/bertos/cpu/avr/drv/kdebug_avr.c
+++ b/bertos/cpu/avr/drv/kdebug_avr.c
@@ -73,7 +73,7 @@
        #define KDBG_UART0_BUS_TX    do {} while (0)
        #endif
 
-       #if CPU_AVR_ATMEGA64 || CPU_AVR_ATMEGA128 || CPU_AVR_ATMEGA168
+       #if CPU_AVR_ATMEGA64 || CPU_AVR_ATMEGA128 || CPU_AVR_ATMEGA1281 || CPU_AVR_ATMEGA168
                #define UCR UCSR0B
                #define UDR UDR0
                #define USR UCSR0A
@@ -190,7 +190,7 @@
        /**
         * Putchar for BITBANG serial debug console.
         * Sometimes, we can't permit to use a whole serial for debugging purpose.
-        * Since debug console is in output only it is usefull to use a single generic I/O pin for debug.
+        * Since debug console is in output only it is useful to use a single generic I/O pin for debug.
         * This is achieved by this simple function, that shift out the data like a UART, but
         * in software :)
         * The only requirement is that SER_BITBANG_* macros will be defined somewhere (usually hw_ser.h)
@@ -232,7 +232,7 @@ INLINE void kdbg_hw_init(void)
                /* Compute the baud rate */
                uint16_t period = DIV_ROUND(CLOCK_FREQ / 16UL, CONFIG_KDEBUG_BAUDRATE) - 1;
 
-               #if (CPU_AVR_ATMEGA64 || CPU_AVR_ATMEGA128)
+               #if (CPU_AVR_ATMEGA64 || CPU_AVR_ATMEGA128 || CPU_AVR_ATMEGA1281)
                        #if CONFIG_KDEBUG_PORT == 0
                                UBRR0H = (uint8_t)(period>>8);
                                UBRR0L = (uint8_t)period;