+++ /dev/null
-# Script for luminary lm3s*
-
-# Change the default telnet port...
-telnet_port 4444
-
-# Port for TCL connection.
-tcl_port 6666
-
-# GDB connects here
-gdb_port 3333
-
-# GDB can also flash my flash!
-gdb_memory_map enable
-gdb_flash_program enable
-gdb_breakpoint_override hard
-
-# ftdi interface
-interface ft2232
-#ft2232_device_desc "LM3S811 Evaluation Board A"
-ft2232_layout evb_lm3s811
-ft2232_vid_pid 0x0403 0xbcd9
-
-
-if { [info exists CHIPNAME] } {
- set _CHIPNAME $CHIPNAME
-} else {
- set _CHIPNAME lm3s
-}
-
-if { [info exists ENDIAN] } {
- set _ENDIAN $ENDIAN
-} else {
- # this defaults to a little endian
- set _ENDIAN little
-}
-
-if { [info exists CPUTAPID ] } {
- set _CPUTAPID $CPUTAPID
-} else {
- # force an error till we get a good number
- set _CPUTAPID 0xffffffff
-}
-
-# jtag speed
-jtag_khz 500
-
-jtag_nsrst_delay 100
-jtag_ntrst_delay 100
-
-#LM3S811 Evaluation Board has only srst
-reset_config srst_only
-
-#jtag scan chain
-jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 1 -irmask 0xf -expected-id $_CPUTAPID
-
-# the luminary variant causes a software reset rather than asserting SRST
-# this stops the debug registers from being cleared
-# this will be fixed in later revisions of silicon
-set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
-target create $_TARGETNAME cortex_m3 -endian $_ENDIAN -chain-position $_TARGETNAME -variant lm3s
-
-# 8k working area at base of ram
-$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x20000000 -work-area-size 0x2000 -work-area-backup 0
-
-#flash configuration
-flash bank stellaris 0 0 0 0 0
-